Note: The Universal Clamp requires additional hardware for constructing the free standing base. Typically this is accomplished using a section of 3/8" pipe secured to a "Floor Flange". This assembly is then attached to a base of your choice - either a flat piece of wood or a block of material heavy enough to provide adequate stability.

1. Secure Adaptor to an Extension, or attach directly to the Clamp.

2. Slide the Universal Clamp onto the 3/8" diameter rod.

3. Adjust the Universal Clamp vertical position and tighten sufficiently to support the weight of Film-O-Clean

The Adaptor (and Extension if used) may be adjusted independently to control the position and orientation of Film-O-Clean. The Input / Output Film Rollers may likewise be adjusted on an as-needed basis.

Important: Ensure the Film-O-Clean Drive Wheel is centered within the film path.